Chelsio Communications N210 Manuel d'utilisateur télécharger pdf (Page 5)

Software Installation

The Chelsio N210/N110 10Gb Ethernet adapter driver software may be downloaded via our

support website at

http://www.chelsio.com. The driver may also be distributed on CD-ROM.

In either case, the driver file will be named chxge-2.1.1-s10.tar.gz. Copy this file to a location on

your system where you have read/write access and enough space to un-tar the package.

Using the gunzip and tar utilities, unpack the driver file. This will create a new directory named

chxge-2.1.1-s10.

# gunzip -d < chxge-2.1.1-s10.tar.gz | tar xf -

Use the cd command to change to the newly created chxge-2.1.1-s10 directory

Installing the i386 driver

Use the pkgadd utility to install the CHLSchxgei package.

# pkgadd –d .

At the prompt, select the number for the CHLSchxgei driver and answer ‘y’ to install the

driver.

Installing the SPARC driver

Use the pkgadd utility to install the CHLSchxges package.

# pkgadd –d .

At the prompt, select the number for the CHLSchxges driver and answer ‘y’ to install the

driver.

Uninstalling the i386 driver

Unplump and unload the driver prior to removal, use ifconfig <interface> down

unplumb to bring down the interface. Use modinfo | grep chxge to identify the module

ID and use modunload –i <module_ID> to unload the driver.

Use the pkgrm utility to remove the CHLSchxgei package.

# pkgrm CHLSchxgei

Answer ‘y’ to the interactive prompts to remove the driver from the system.

Chelsio N210/N110 Installation and User Guide for Solaris Release 10, April 2005. 2

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Chelsio Communications N210 Manuel d'utilisateur Page 5